On which links along the path between computer 1 and computer 4 will a VLAN ID tag be included with the frame? i think the right answer is C,E,F not C,E Reply joseph capobianco says: November 21, 2013 at 11:06 am about question 15: Refer to the exhibit. What is a valid consideration for planning VLAN traffic across multiple switches? Configuring interswitch connections as trunks will cause all hosts on any VLAN to receive broadcasts from the other VLANs
Which two statements describe the BIDs used in a spanning tree topology? (Choose two.) They are sent out by the root bridge only after the inferior BPDUs are sent. Which two statements are true about the default operation of STP in a Layer 2 switched environment that has redundant connections between switches? (Choose two.) The root switch is the switch with the highest speed ports
Ccna 3 chapter 1 v4.0 answers 2011
Use Layer 3 access control features on D1 and D2to limit access to the HR servers to just the HR subnet.Move all HR assets out of the data center and connect them to S1. What is the likely impact of moving a conventional company architecture to acompletely converged network?Local analog phone service can be completely outsourced to cost-effective providers.The Ethernet VLAN structure is less complex.A shared infrastructure is created resulting in a single network to manage.QoS issues are greatly reduced.There is less bandwidth competition between voice and video streams.6
What is an advantage of using LACP? increases redundancy to Layer 3 devices decreases the chance of a spanning-tree loop allows automatic formation of EtherChannel links provides a simulated environment for testing link aggregation decreases the amount of configuration that is needed on a switch for EtherChannel Which statement is true regarding the use of PAgP to create EtherChannels? It requires full duplex. What are two reasons why the ping messages that are issued from Laptop0 towards Laptop1 are failing? (Choose two.) The channel group mode is not set correctly on the switches
Which two pieces of information are used by the OSPF MD5 algorithm to generate a signature? (Choose two.) secret key OSPF message OSPF router ID router hostname interface IP address A network engineer is troubleshooting convergence and adjacency issues in an OSPFv2 network and has noted that some expected network route entries are not displayed in the routing table. Which two requirements to form an adjacency need to be verified? (Choose two.) Verify that one of the interfaces that connects the two routers is active and the other passive
No comments:
Post a Comment